As the result of FDA regulations enacted on May 9, 2000,
changing the standards for lead wires, the type of lead wire a
user will need depends on the type of TENS unit in use. The
Lumiscope Company has developed and carries three different
styles of lead wires in full compliance with FDA regulations
that fit our TENS unit machines now in use.
LW-36N 360º Rotating Connector
LW-36A LW-36N Lead Wires, with Removable
Adaptor
LW-36/2 Prong Lead Wires for TENS units
with two-pin output connector
If you have been distributing our TENS unit products, we
suggest that you carry a full complement of the three lead
wires to satisfy all possible customer requests. Please feel
free to contact us with any further questions.
Use this
chart to determine which lead wires you should order for
your unit:
TENS Product
Lead Wires to Use
2000-T (Distributed before May 2000)
LW-36A
2000-T (Distributed since May 2000)
LW-36N
APC-3000 (Distributed before May 2000)
LW-36A
EMS-400 (Distributed before May 2000)
LW-36A
EMS-400 (Distributed since May 2000)
LW-36N
LUMI-TENS (Distributed before May 2000)
LW-36A
LUMI-TENS (Distributed October 2000-May
2001)
LW-36/2 Prong
MICRO-400 (Distributed through May 2000)
LW-36A
SW-1000 (Distributed before May 2000)
LW-36A
SW-1000 (Distributed October 2000-December
2000) * Note: SW-1000 units with the following serial
numbers were distributed from October 2000 to December
2000: S04901-S056700, S095001-S096781, S13001-S13500.
